Everything needed to swap your truck from stock 88-00 OBS / GMT400 SINGLE CAB / EXTENDED CAB / 2 DOOR TAHOE / YUKON standard handles over to Kodiak handles.
This is a PAIR of handles for a regular cab, two door tahoe/yukon or extended cab.
Two pairs are needed for crew cab / suburban / tahoes
Comes with
Standard Kodiak Handles x2
Kodiak Latch Rods x2
Kodiak Latch Rod Clips x2
Kodiak Lock Rod x2
Kodiak Lock Rod clip x2
Kodiak Lock Pawl x2
Lock Cylinder clip x2
Door Latch Retainer Clip x2
This particular kit is also offered in colormatched finish. *see other listings*
Base Kodiak Door Handle Kit (2 DOOR)
To change your door handles over to these robust kodiak door handles, you must have atleast a flat head screwdriver, phillips screw driver, a 10mm with an extension, a ratchet and some patience.
Step 1: Make sure your window is all the way up.
Step 2: Remove both the door handle trim, power window controls, and the mirror trim pieces.
Step 3: Start gently pulling the door panel away from the door.
Step 4: Remove the interior light out of the door.
Step 5: Lift the door panel up to separate it from the door.
Step 6: Remove the 2 10mm bolts holding the door handle in.
Step 7: Remove the door handle and remove your locks out of your door handles. ( The lock cylinders have to be swapped from L - R )
Step 8: Install supplied lock rod and latch rods onto your new handles.
Step 9: Remove old latch clips and install new ones
Step 10: Fit up the kodiak handle, slide the latch rod into the latch mechanism and push the lock rod onto the lock clip.
Repeat steps 2-7 in reverse.
